hi mike! you should be able to see through the pilot jets,from front to rear, [just]..tiny hole, make sure the main body of the carbs is clear? cheers!!mike151 wrote:Hi, interesting to hear about middle cylinders needing bigger jets, I think someone's cocked up & put the bigger ones in the right hand pair on these.gonna get my main set off again & check them ,cos bikes still not quite right, don't think I cleaned needle jets properly,ie didn't take them out.
gk71f
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
bartman400
- Settled in member
- Posts: 15
- Joined: Sat Feb 08, 2014 4:53 pm
- Bike owned: gsxr400gk71f
- Location: central scotland
Re: gk71f
-
mike151
- Settled in member
- Posts: 22
- Joined: Fri May 09, 2014 6:53 am
Re: gk71f
Was at an autojumlbe a few weeks ago & there were some Gsx 550 carbs which looked exactly the same as mine but had mikuni written on them. I roughly measures them & found them to be the same. Wondering if jets are available for these mikuni carbs & whether they'd work on a gk71