I´m rebuilding my NC24 here for the 2nd time. 1 week ago i started it and let it run for 15 minutes to warm it up.
The battery was a bit weak, so i connected a normal car battery too.
Yesterday i wanted to start it up again with a new wiring loom (the old was for racetracks only).
But everytime i connected the plug to the starter relays (near the battery) - the 30A main fuse blew out.
I checked all wirings and didn´t find anything. So i put the old wiring loom in again, to check if the new has a failure - and again the main fuse blew out.
Could that be the regulator/rectifier? Perhaps i destroyed it with the car battery?
Cheers!
Peter
PS: I´m sorry if my english isn´t very well...
