Hi,

I am thinking of adding new fairings to my NC29 over the winter, does this fairing meet ACU regs?

The catch tray area looks a bit too small



Thx

I just got one as well and had to fibre glass in a catch tray... I also had to make a few admendments (cut away bits) to the fairing to fit around the SES rearsets, the Nassert Beet exhaust, fireblade rad and the fact the bottom section was too long so had to cut away 5cm to get the rear wheel to fit. But now that Ive done all that, it looks great. Col

Cheers for that Col

Would you happen to have a photo of your Racer? it sounds good!

Did you go with the Tyga race rear end too?

My racer uses the tyga front end, can be seen in the 'new arse end on my race' thread.

I didn't go with the Tyga rear.

Had to do much the same work as mentioned above when fitting.

I'll stick a pic up later today when I put the fairing back on... installing a quick shifter today... and no, didnt use the Tyga seat unit, I'm using a modified 2004 CBR600RR seat. Col

When I hear what people have done to their NC29 racers, it makes me realise how much more work I need to put into mine. My bike is low budget and pretty much standard....

I'll get there one day :)