Hey

My NC29 came with downpipes and a slip on micron can.

the problem is someone had welded the flanges on squint, so it the bolt holes dont line up correctly on the headers, and it was a bad welding that they put holes in the pipes.


so i bought another set of downpipes from a guy selling them on here, through ebay, any way the look in brill condition, but they have flange at the end for a bolt on exhaust. i dnt fancy buying another exhaust can again.

do think it possbile to cut of the flange and just slip the exhaust on, but it looks awefuly close to the bend.

Thanks :D

yeah i did the same on mine, make sure you cut as close to the flange as possible

scratchin wrote:yeah i did the same on mine, make sure you cut as close to the flange as possible

Ooh, I like that can Scratchin, where did you get it from? Price?

Thanks

got it off evil-bay only cost £50 new, i will see if i can find the guys email for you, sounds really good and the quality is good too

Thanks very much