Hi all i'm new on here and will post bike pics in the intro section soon. I am trying to fit these crash bobbins bought on ebay to my bike : http://cgi.ebay.co.uk/NC30-RVF-Heavy-du ... 1|294%3A50" onclick="window.open(this.href);return false;

http://cgi.ebay.co.uk/NC30-RVF-Heavy-du ... 1|294%3A50

Which side is the long bolt for as both sides seam to only need the smaller less machined out bobbin?

should have said they are going on an nc30

Cannot se ebay at work but when I had some R&G bobbins fitted you got two different length spacers.

The engine is not symetrical and so the left hand front cylinder is further in board that the front right - if that makes sense.

2 4
1 3

You will need to cut your fairings if you buy anything other than the "non drill R&G" ones.

they are the 'cut your fairing' type pictured.
and as has been said - the longer one goes on the side which is further 'inside' the frame if that makes sense?!!

Smev

nice one thanks guys, will have a look again tomorrow