Please could someone advise me on the thread size so I can get a rotor puller. Also does anyone know the cheapest place to get one. Unless someone in Bristol has one I can borrow for an evening. Thanks

I took the cover off my NC30 flywheel/generator, undid the nut that holds it on and had to go in for my tea ( the wife wouldn't be happy if i missed it!)
Then went back to remove the flywheel the next day to find it had fallen off of its own accord!!
Maybe its worth giving this technique a try!!
I think it might have ben all the oil from my slight off which had got in behind the rotor and loosened it up. - gravity did the rest!

Smev

Not 100% sure, but I think Rick Oliver sells them?

rick o definately sells them as i bought one from him last year..............i think they only cost £5 or so delivered from him so get in contact.



william

scotjell wrote:Please could someone advise me on the thread size so I can get a rotor puller. Also does anyone know the cheapest place to get one. Unless someone in Bristol has one I can borrow for an evening. Thanks

M20 x 1.5

Rick O sells them if you want to support a forum member.. there cheap too :)

Thanks. Rick returned my call but his advice was to see if I could locally purchase a M20x1.5 pitch bolt. Which I did and that was good enough. Thanks.