Page 1 of 1
Exhaust Collar Dimensions
Posted: Fri May 01, 2009 8:16 pm
by blakdog
Would anybody know the exhaust collar dimensions for an NC30. I have to get mine repaired and they disintegrated when I took the exhaust off.
cheers
Re: Exhaust Collar Dimensions
Posted: Fri May 01, 2009 9:02 pm
by mrdidlydingo
When you say collar to which do we refer, if its the ones that join the front headers to the centre section try Honda there approx 4 quid a piece ! if not let us know I for one have an exhaust hanging about to measure !
Re: Exhaust Collar Dimensions
Posted: Sat May 02, 2009 6:24 am
by elrikos
don't know the sizes i'm afraid but when mine did this on my old nc30 i took them down to a fabricators and got them to weld a bit of stainless tube on each of them instead of using collars. I then cut some slots in the end and held it all together with silicone and jubilee clips (apparently silicone is the stuff to use on stainless systems rather than exhaust paste?). Worked brilliantly and only cost me £15.