http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0210157388
any1 had one of these from him, if so any good? cheers

take it from the bids shootin up on ebay that there well sought after on here lol!

Will fitting one of these effect the fueling and need changes in jet sizes? also is there any modification needed to fit it the an nc35, as i have heard that the upper rad sits slightly hight than the one on the nc30.
Jim

yes and no ,
i have two of these ,both from the same seller ,fitted to my castrol bike and track bike,the castrol bike one is no more than a glorified heat shield,i removed the front flap from the frame cross member and fitted this,everything else was left in place (ie the filter base,air box lid etc etc)
the track bike is completely different,and it is part of the HRC set up the same front flap was removed,along with the complete airbox set up,base,filter...everything...so all the bike has now is the HRC tray below the carbs and the nothing else
both where fitted to an nc30 and i don't think you could fit this to a '35 without modifcation to the bike and carb set up

i have one fitted to my nc30, not been out on it with it in yet, i still have the full standard air box fitted, but removed the little heat sheild.
it only just fits above the top rad, o and it does look cool as well i think

The bloke's selling breeze blocks at £15 a pop

lol! i noticed that 2, must be his form of a jack down kit! :D