does nayone know what the threads and lengths are of all te fairing bolts on the nc30, i keep loosing the ones in my tail unit (down to three now) so im gona replace them all with stainless

cheers spike

rick oliver sells them from memory around £1.50 each

nah i just need the thread sizes cos im going stainless

They are a standard metric thread, and are either 6mm or 8mm.

I about 75% they're 8mm.
I'll check in the morning, i have a few large headed screws in the garage to replace the ones i lose.
I never check the size because i can just get some more out the store at work when i need them.

spike, the screws from rick are stainless with alloy cup washers stepped to fit the panels like the original screws and hold everything in place without damaging your panels, much better than these kits of the bay etc, a nice finishing touch .

They are a standard metric thread, and are either 6mm or 8mm.

I about 75% they're 8mm.

I'm thick, the fairing screws are a 6mm standard metric thread.
I was nearly right.

yeh im looking for stainless tapered bolts with a stainless tapered washer, like the ones from probolt but cheeper (if possible) i dont want any ally cos im afraid after a couple of years it will just corrode and il have to get new again

have a look on pro bolt. http://www.tastynuts.com" onclick="window.open(this.href);return false; even if you don't want to buy from there they have the sizes.

AL