Hi All,
Changing the alternator this weekend, I've come to remove the old gasket and it's rather solid and not really wanting to come off!
I saw another post in the CBR section about gasket scrapers and wet and dry, just wondering if anyone had any other suggestions?!

It's soaking in warm water at the moment...

:D

you can use a stanly knife blade if you have one. just be very careful!!!

Also if lying around a wallpaper will do the job also.

Is this a mod you are doing alone Mat or this the thing I remember reading on Gforce's blog?

Snap On Roloc disc machine.. every time..

dx4 wrote:Also if lying around a wallpaper will do the job also.

Is this a mod you are doing alone Mat or this the thing I remember reading on Gforce's blog?

Just me. Replacing the alternator, it's been changed just nned to remove/ replace gasket.

France & Li Asia Tdg wrote:Snap On Roloc disc machine.. every time..

? Haven't heard of those?

A little bit of nitro mors applied using an artists brush, being very careful not to get it on anything. I tried it, it softened the gasket and made it easier to scrape with a stanley blade.