see it on a few bikes running race rearsets. instead of F'ing about with the standard rear brake light switch, pop a pressure switch by the mastercylinder/banjo bolt and wire in the 2 cables that were in the normal road switch thingy.


had a brief look about, but not seen them anywhere. also the other thing is to make sure they are the correct banjo thread for the nc30 rear brake unit.


anyone sell or know where to get one from, as im hesitant to fit race rearsets before i have this sorted as ride on the road.

Just been covered in this section yesterday mate.
http://www.400greybike.cc/newforum/view ... =24&t=5869" onclick="window.open(this.href);return false;

TheRehabKid wrote:Just been covered in this section yesterday mate.
http://www.400greybike.cc/newforum/view ... =24&t=5869" onclick="window.open(this.href);return false;

typical. it was yesterday i was thinking about posting as well!!! cheers