i have a nc30 . been offered a set of good set of just serviced nc35 (USD) forks and yokes cheap (cheap=£200 but need to let him know today!!)..

question is...how easy would they be to bolt into the nc30?

initially the answers im after are

# yoke stem the same? i.e will it bolt straight in or need a spacer machined or stem swap

# is the nc30 wheel and discs the same dimentions etc? ( ill source callipers elsewhere so not bothered about them now) i could always get a rvf front wheel etc later to finish it off!

# front spindle and spacers??

other things like i know id need clipons etc anyway are important at this time .. its more that i need it a rolling chassis due to current storage space limitations.

also whats a standard full nc30 front worth to recup some cash. (well whatever is leftover/ i dont need for the above)


cheers
j

You need a fitting kit from Rick Oliver - PM him on here.. stems are different

Wheels and discs are the same.

Internally they are pretty much the same...

You need the spindle and spacers too I believe

front end worth from £50 to £100 if you are lucky...

cheers for the advise, ill go another way.


in hindsight i may give it a miss...