Page 1 of 2
Check out this beast!
Posted: Sat Dec 20, 2008 8:24 am
by fzrtim
Just found this on the pb forum.
Fzr 400 frame, fireblade motor....F***ing mental! And the triumph daytona 650 fairing fits so well. Makes the 600 conversions look tame....
Check out 'built for go not for show' in the project area of the pb forum. (sorry dont know how to make a link to the site!)
Re: Check out this beast!
Posted: Sat Dec 20, 2008 8:43 am
by dobbslc
HOLY SH*T better get my finger out now!
PS where the F does he sit?
Re: Check out this beast!
Posted: Sat Dec 20, 2008 11:56 am
by Sligeach
judging by the size of the rear sprocket and a 929cc motor it mite be a bit keen to get light at the front
Re: Check out this beast!
Posted: Sat Dec 20, 2008 7:45 pm
by Evilchicken0
Posh front end as well.
I knew there was a conversion with a Blade 918cc in it
Re: Check out this beast!
Posted: Sat Dec 20, 2008 9:33 pm
by CMSMJ1
That is superb...kickass.
I'll bet it spits in your face sat behind it in the queue to go out on a TD.lol
Re: Check out this beast!
Posted: Sat Jan 10, 2009 7:57 pm
by Thunderbike_steve
Wow thats cool
I suspect there is a little more work involved than the 600/660 conversion but I could be tempted. Think i'd make the engine a big bang motor though through getting special cams made up just for the full moto gp sound effect
Re: Check out this beast!
Posted: Sat Jan 10, 2009 8:14 pm
by wullvfr
declangaelic wrote:929cc motor
Evilchicken0 wrote:Blade 918cc in it
which one is it guy's
william
Re: Check out this beast!
Posted: Sun Jan 11, 2009 12:02 am
by Evilchicken0
I Think it's a 918.
There was another old 3TJ special in Performance Bikes ages ago that used a 918 Blade engine. The guy who owmed it was here (well the old forum) and then had it on e-bay a little while ago. The front sprocket nearly lines up and the back mounts drop in ... I think it's just the top left engine mount that needs modding ... and the head needs bracing of course
Re: Check out this beast!
Posted: Sun Jan 11, 2009 10:34 pm
by fzrtim
saw it on ebay and wanted to buy it but was too late!
Evilchicken0 wrote:I Think it's a 918.
There was another old 3TJ special in Performance Bikes ages ago that used a 918 Blade engine. The guy who owmed it was here (well the old forum) and then had it on e-bay a little while ago. The front sprocket nearly lines up and the back mounts drop in ... I think it's just the top left engine mount that needs modding ... and the head needs bracing of course
Re: Check out this beast!
Posted: Sun Jan 25, 2009 9:06 pm
by Yamamoto
If it was the blue one with some pink bits here and there on it i owned it a few years ago :) Went like a rocket but needed the forks changing as they weren't up to the job. It was a very tidy conversion and wish i hadn't of sold now but thats like many of the bikes i've owned in the past :)