Hi all,

New to here but have looked at the site a fair bit for information previously and found some really useful posts.

I inadvertantly bought an NC24 a couple of years back and it has made it to the top of the jobs list finally.
Started by stripping forks and going to give rebuilding them a shot.
I noticed the spacers were different lengths when I took them out which was a rookie error as now I am not sure which one is for which fork and manuals I've found from here don't seem to specify. All other parts I know are right as they have been kept separate. Planning to just offer up and see how they compare as the springs are the same length and everything else is definitely right so as the springs are the same they should end up equal when put next to each other (I assume, maybe wrong).

Any advice from anyone is much appreciated