I all.

Does anyone have a Honda vfr 400 nc21 hydraulic clutch pushrod they could measure the length for me.

I am putting hydraulic clutch on my nc24 and an using a vfr 750 rod that I need to cut down.

If someone has a rod from nc21 with hydraulic clutch that they could give me accurate measurement that would be great.

Thanks in advance any additional be welcome.

Nick

Did you sort it after??

No not sorted yet I have all the bits just need length of rod I need.

Can't find nc21 rod so just need cut down the 750 one I have.

Can't seem to find an answer anywhere online.

there will be an answer on this forum somewhere - on on the archived older one. get your google fu rolling

I want to say that a user DAC did this...and so did..hmm - hannahkournikova? Maybe royster81 too?

Am sure it's out there - this is not a new road

Thanks

I think from looking on here etc that is is 338mm and I think I will go with that and see how it goes.

I have seen the previous before write ups for these and one mentions it is 338 mm but this was on nc30, which I think would be the same for nc24.

Fingers crossed.

Nick01 wrote: Wed May 26, 2021 12:20 pm Thanks

I think from looking on here etc that is is 338mm and I think I will go with that and see how it goes.

I have seen the previous before write ups for these and one mentions it is 338 mm but this was on nc30, which I think would be the same for nc24.

Fingers crossed.

viewtopic.php?f=22&t=37519&hilit=nc21+pushrod

Hows that? Some of these guys do still post and visit so you might PM them and confirm

I have messaged and hopefully we will get there. I will be having a look at weekend so fingers crossed.

I have a 21 rod here..(in fact I have the whole lot complete ready to retro-fit,but haven't got round to it yet)..I will measure the rod later bud

Yep,338 or 13 inches bang on....

Ideal thanks for measuring. I have cut to length and put on. Just waiting for Venhill to send banjo as kit they send had straight fixing which is no good.

I will let you know how get on.