Hello, I am hoping someone here is able to pass on some measurements from an NC30 or NC35. I am looking for the outside measurement of the 32mm carburetor where it attaches to the intake manifold rubber sleeve. I am also looking for the outside measurements of the intake manifold where it also attaches to the intake manifold rubber.

Cheers,

Dave

HI Dave,

I think you'll find these in the HRC manuals perhaps, or certainly something in them that might give you a pointer

They are on the http://www.400greybike.com/ root of this website

Hello, Thanks for the direction but I looked through the manuals and could not find any reference to the measurements I need... If it makes any difference, I am trying to figure out if the rubber manifold sleeves will work on 32mm FCR on a 1WG manifold.