Hey guys,

is it normal that I can turn the rear wheel (while on a jack) about 0,5cm to 1,0cm before the sprocket/chain starts moving?
I have mentioned the clearance this Weekend while cleaning the bike. Is it normal on the NC24

Or do you think that the dampers are worn out? See number 2:
https://www.cmsnl.com/honda-vfr400rii-n ... ml#results

greetings
Kai

sounds normal, its the slack in the cush-drive rubbers..

you can take off the cushdrive cover to see the actual phsyical condition of the rubbers..