Picked this up from ebay last week.
It's been messed with but it does had the v5.
No engine or loom or clocks. Fairing is I right miss match and the subframe is all wrong,
But the tank is solid. All the bearings will probably need replacing but it's a good basis for a complete built from the ground up project (long term project).

Sent from my SM-N910F using Tapatalk

Theres not a lot to being got on with there unless you can source a motor loom etc cheaply and you already have some of the other parts could be an expensive challenge when finished.

Also got these bits with it as well.


Sent from my SM-N910F using Tapatalk

Subframe looks like could for a tyga seat unit

Don't know what it's off but it's for zxr rear fairing. Anyway it's definitely not staying.

Sent from my SM-N910F using Tapatalk

If they're standard bar ends and front wheel Is straight id be interested in those if you decide to break!

What's withe the bar ends? Your the 2nd person to ask.
I'm keeping it for a project bike. It's going to have a different engine in but not surewhat yet.


Sent from my SM-N910F using Tapatalk

Lol...I was going to get them for the guy who probably asked first(redmazda?).....

How about an er6 engine or something?

wow, i've cut up and thrown better stuff than that!

Erm.. any ideas so far?

Could take time and rebuild a nice bike but that will cost way more than just buying a good condition one.

You could build something crazy and one off... fireblade engien? vfr1200 engien? :D

who knows.