Hi all
I have just bought an '88 nc23 that I plan to use solely on the track. Therefore I will be removing the speedo completely as it is not needed, and I want to know whether I will need to fit the resistors at both ends.
Is it as per the document in the library, ie; 1 fitted in the speedo plug, and 1 fitted near the CDI plug.
Many thanks in advance
Ian

you can fit the resistor either at the CDI end or the Speedo end, you don't need to do both.
I'll be up at the CRMC round at Cadwell later this year with my NC23 (Trackday on the Friday and spectating over the weekend) if you want to come & have a chat about NC23 trackbikes and have a look at the mods to mine.

Hey Pod.
Thanks for that.
I'll be at Cadwell too for the CRMC meeting, on my 400/4 No: P66 normally.
How will I be able to locate you?
Ian

I'll probably only be there on the Friday & Saturday so if i don't find you, look out for this yellow bike
viewtopic.php?f=69&t=50714&start=40

Ok matey, will look around the paddock for you.
As I say I will be there all weekend, hopefully we normally park up on the left side as you go down towards the track.
Ian