Hi everyone.

On a twinstack exhaust should the bore of the cans be the same bore as the pipework? The pipework that I have is 1 1/2 inches diameter.

I've just had a bloke make me some straight through cans up and they are 1 1/2 inch inlet and 2 inch bore through the silencer. Is this right?

Has anyone else had some new cans for a moriwaki system made up? Any chance of the dimensions?

Thanks

Hi Tom, I got your PM, but haven't had the chance to reply yetm but here's the measurements of my cans,

Inlet - 38mm
Outlet - 44mm
Slieve bore - 85mm
Slieve length - 395mm

The perforated tube goes on the outside of the inlet pipe and is on the inside of the outlet pipe, if you get what I mean. If you are not happy with them then I'd be straight back asking for them to be corrected.

thanks for getting me the measurements. im going to get them sorted

did you have to get another can strap? did you get it with the cans? just benn looking and its quite a big difference between the moriwaki cans and the ones i've got made up

I got the Mori strap with the system and it fitted the new cans perfectly

Old cans,



New cans,

tom wood wrote:did you have to get another can strap? did you get it with the cans? just benn looking and its quite a big difference between the moriwaki cans and the ones i've got made up

mercury made a really nice can strap but getting the hold of them is hard work atm ...

viper_biker wrote:I got the Mori strap with the system and it fitted the new cans perfectly

Porn!

i've never had twin stacks, it's on my list of things to do before i die!

the strap fits around the bottom can ok. But when I try to put it around the top I end up with gap of about 6mm where the 2 ends should clamp together.

do you have the tabs of the can strap either side of the exhaust hanger or both on one side?