Hi I was wondering if anyone knew how wide the wheel spacers are for an nc29. I think the left is thinner than the right side. I read the inside/outside diameter is 21/28 but cant find the width of the spacers. As usual I cant take my bike apart to check until Jan/Feb.

These are to suit an R model 1994

Part number for the left is 44312KV3700,

Part number for the right is 44311mr1000, note the earlier nc29s had a part number of 44311kv3700 for this spacer, so I dont know if there is a difference.

Anyone know?

Sorry Dave can't help on this one but what's wrong with the ones you're using now? Upgrading time?

cbr400rrn wrote:Sorry Dave can't help on this one but what's wrong with the ones you're using now? Upgrading time?

Yes, due to mine looking a little dirty and a never ending cycle of cleaning salt and grime off, spoiling the look of the bike in that area. I thought I would get some nice shiny Titanium ones as most of my external bolts are either Stainless or Titanium, these are so much better as they stop shiny and look good, that also means less work for me.

Sadly I possibly seem to have trouble with at least one that I ordered as just looking at it I can see its wider, despite supplying the correct part number used by Honda, although for some reason I have seen three alternative part numbers that seem to be this same part, its a nightmare hoping the part is the same and the dealer selling the upgrade is also unsure, so you go for it and hope its right. So will get my cousin to turn it down if i can get the correct sizes. But if no one knows it I will have to wait until I can get the wheel off due to work etc..

If you are going to buy fancy new ones go for captive they save so much hassle