Hi All:

I am making Titanium Axles for the NCs. A long time ago, I compared the NC-30, NC-35, CBR600F-2/3 and a few other bikes to find the only dimensions that were different were the lengths. Here is a link to the drawing that I will be making the axles off. Can any of you, or several of you, check out my drawing and compare the measurements to your front axles (NC-30 & NC-35) to make sure I am on the right track before I cut lots of expensive Titanium rod?

https://www.dropbox.com/s/iav7dk6rozbxp ... 3.pdf?dl=0

I look forward to the feedback.

Mike Norman
G-Force Engine Development
www.mngforce.com
There is no such thing as "Too Fast"

How much these gonna be?
Can measure mine later this week.

Hi Mike,

Ive been looking into an endurance type front wheel spindle.

viewtopic.php?f=22&t=52965

Have been speaking to Rick Oliver about it, would it be something you'd like to be in on?

Cheers
Tim

I'd be very interested in this, please put me down for one.

Sent from my SM-G935F using Tapatalk