As the FCR inlet boots are rarer than honest politicians, I've decided I need to go DIY. After much searching this http://www.mycarperformance.com.au/rubb ... mm-id.html seems to be the best option. Silicone and radiator hose aren't fuel resistant. Hopefully I can cut these to the right shape and use a Dremel to open each end of the cur piece to the 35mm required for the inlet port and 37mm for the carb spigot, then clamp them on. The hose should have enough stretch to fit snuggly and enough rigidity to hold the carbs without them coming off.

I've ordered a metre so there is enough for a few stuff ups. I'll post progress as it happens. The hose is going to take a couple of weeks to arrive

If anybody has a set of these rubbers they could measure for me it would be much appreciated.

Matt

Any chance of making another set for me as I'm in the same boat? I'd pay you of course

Yakama wrote:Any chance of making another set for me as I'm in the same boat? I'd pay you of course

Let me get one set made first and I'll tell you then

Sounds good

Liam, do you have any good pics of the rubbers that I can use to get an idea of there height?

Matt

I'm afraid my fcrs came without them but I will see if I can find any pics on the net

Yakama wrote:I'm afraid my fcrs came without them but I will see if I can find any pics on the net

I've searched for hours and haven't found anything good

If I can get a set of these replicated Liam would you be interested? No promises, but we might get lucky. NFI as to the price yet.

Yeah I'd buy a few sets to have spares, you got an air box to go with yours? As I've got the mould now so can get new ones made

Yakama wrote:Yeah I'd buy a few sets to have spares, you got an air box to go with yours? As I've got the mould now so can get new ones made

Is that for the NC23 or the NC29?

I might also be interested in the inlets for a set of FCRs...