Hi guys,

I used this http://www.veaminicori.talktalk.net/Art ... iction.pdf guide to de-restrict my NC35 and now after I accelerate to a certain point in every gear, the bike starts to struggle. It's sort of like it's trying to half restrict the speed that I'm currently going, but not completely stopping me from going faster.

I bent that small tab but it wasn't completely 100% flat, more like 80-90% flat, does it have to be 100% flat? Or can I just clip off that small bent bit altogether?

Cheers

Does it cut to 2 cylinders around 5-6k rpm

as above, did you re-connect all the wires for the speedo restictor circuit? if they are not connected properly the bike will cut the rpm at 5500

That must be it. I will recheck tomorrow. Cheers guys

Silly me put the little metal tab the wrong way. Was meant to go over the cogs, I put it under. All fixed now