Hi, after a recent dink I have been putting my bike back together. The upper fairing frame was bent up and I have straightened it out as best I can without a reference.

Could someone please tell me what the distance is between the very ends of the two stays that the wing mirrors bolt on to. Test fitting the top fairing and it seems a bit off.

Also my clutch basket needle roller bearing is worn (not too bad but it needs replacing). Cost in UK/EU is a piss take, I can get one a third of the price in the States. Is this a Yamaha specific bearing or is there a ref number to go to a bearing supplier with? Failing that my money is going State side with a bigger order to take advantage of their lower prices and save on some other overpriced bits and bobs here.

If I make an order I'll post again so that anyone who wants something (no heavy exhausts or engine blocks ) can let me know and I will add it to my order and post it on to save you the international postage.

Cheers

If this is the distance you need, I've measured it to be about 14 & 3/4 inches or about 37.5 cm.

Wow, that was fast Evoluzione

Thanks very much for going to all that effort with the photo as well. That is exactly the measurement I needed. Mine were at 16" or 41cm so close but no cigar.

Cheers