https://www.youtube.com/watch?v=lZd539zd1xo

SOME ONE TELL ME IF THEIR SHOULD BE A PIN IN HERE OR IS IT THE PILOT JET AIR HOLE FEED?
COS THEIR IS ANOTHER LITTLE JET WHEN U SCREW OUT THE PILOT HOLE EMBEDED IN BEHIND
PUSH CATGUT IN THE FRONT HOLE WHERE I THINK THEIR SHOULD BE A PIN AND IT COMES OUT ROUND THE SIDE OF THAT EMBEDED IN JET UNDER THE PILOT JET
AND IF THEIR SHOULD BE A PIN IN HOW LONG?

No pin goes there, it is an open hole. The pilot's are in the opening on the right, way down in there. The opening you are showing does not have a jet screw into it.

THANK RSGP
Just found that out today after a bit of searching around the two other jets one under the pilot was not that clean and their is a slot at the side of it near its base so air is pulled into this from the hole i thought was blocket and mixed with the fuel going across into the pilot jet under the pilot jet if u get my meaning cleaned out the opposite side also the emulsifier thats down that ajacent hole which screws out so in all thats 2 other jets that r not on tony sleeps carb paper on here. tut tut
regards john

So i was thinking bollocks lol