Hello all. first post on here. My name is nick. bought a nc29 in February realy cheap needing a full rebuild. so far I have stared with a clean frame and built up the rolling chassis and engine. These bikes are extremely well built. The one I bought had been sitting out side for a few years and all ive had to do so far is refresh some of the bearings and give everything a good clean, polish and paint. Pretty much the whole bike was unchanged from when Honda made it so its been the easiest rebuild I've done. Ill post some pics as soon as I figure out how.

Quick question. I have bought a hrc rear master cylinder delete kit, gone to fit it and it seems that the master cylinder outlet is too big so the pipe doesn't actually fit. does any one know where to get a smaller outlet? Its just the plastic end of the rear master cylinder where the reservoir pipe fits ..

cheers chaps

On the one i fitted to my nc29 ,i just heated the pipe up a little with a hot air gun till it was soft enought to stretch over the fitting! Been on there 2 years and still going strong.