ok who's shoehorned what onto which then??

My NC23 is now sporting a Quill from a zx7r!! ok its pointing the wrong way a little but my gawd it sounds soooo mcuh yummier

so what have you fitted witout going to a slip on fitting??

I've got a micron cabonfibre can on mine. combined with the GF stainless downpipes, it sounds fantastic. :D

Fluffy wrote:ok who's shoehorned what onto which then??

My NC23 is now sporting a Quill from a zx7r!! ok its pointing the wrong way a little but my gawd it sounds soooo mcuh yummier

so what have you fitted witout going to a slip on fitting??

Was that a direct fit? Bolt on?

a very small amount of filing was required and it bolted on.... its not quite pointing the right way tho as although the stud spacing is 98% the same they are rotated a few degress different, the exit port currently points accross my rear tyre
(one way to warm it i suppose!)
so only really works with a round can.... which is going to get shortened and in that process the exit port rotated a little :D

my 29 is running GF pipes with an art stainless bolt on, it sounds fantastic, although the neighbors dont agree! if im honest id prefer a titanium can but i dont know of any that fit

stainless steel custom 4 to 1 pipes with carbon art can purrs like a cat

I have stainless steel 4-1 then a slip on can, not sure of the make. I really want to change the can but I'm having problems finding a slip on to replace it!

I have got a 10.5 inch str8 through stubby can on my babyblade (NC23) bought it of ebay spent ages finding one i liked there is no markings on it so i think its custom made for my bike looks sweet though so if you get one made or find one get it also it sounds lush much different sound to a longer can and looks the Bo***cks!!

that straight through i think is a guy off the MSCninjas forum
i'll see if i can find the link

*IF* the can has a riveted end, why not drill the rivets, rotate the end piece and re-rivet in place.....