Page 1 of 1

When fitting R&G frame/fairing protectors...

Posted: Fri Oct 17, 2014 6:43 pm
by manicguitarist
...the non fairing modification type...

Do take care with the routing of the cable from the sidestand...

I managed to crush mine ... :oops:

The bike worked but the side stand light wouldn't go out.

On investigation one wire had its insulation cut and was shorting out against the frame.

Insulating heat shrink applied...all is well. :oops:

Re: When fitting R&G frame/fairing protectors...

Posted: Fri Oct 17, 2014 9:37 pm
by Neosophist
i take it this is to an RVF then :)

Re: When fitting R&G frame/fairing protectors...

Posted: Fri Oct 17, 2014 9:49 pm
by manicguitarist
Yes it is. Curious though - how did you know?

Re: When fitting R&G frame/fairing protectors...

Posted: Sat Oct 18, 2014 12:25 am
by Loudandproud205
NC30 doesn't have a kick stand light, or if it does mine doesn't work.

Re: When fitting R&G frame/fairing protectors...

Posted: Sat Oct 18, 2014 3:46 am
by lukemillar
and it is written under his username on the left! ;)

Re: When fitting R&G frame/fairing protectors...

Posted: Sat Oct 18, 2014 10:06 am
by manicguitarist
Oh yeah.
D'uh!
:)