Page 1 of 1

cbr400 rr

Posted: Mon Aug 11, 2014 9:40 pm
by thrushstar
hi , i hope iv posted this in the right section, bought the wife a cbr400 to use whilst we sort her nc30 out, might seem a silly question but the lacquer has peeled on the tank but the paints good, how do i remove the remaining lacquer. also what lacquer is good to use. cheers in advance ;)

Re: cbr400 rr

Posted: Mon Aug 11, 2014 10:49 pm
by kstation
Hi pal no I idea how to get only the lacquer off but I know halfords sell lacquer designed specifically for petrol tanks good luck with it mate

Re: cbr400 rr

Posted: Tue Aug 12, 2014 12:45 pm
by Davez29
There are painters who could sort de-lamination but who and where I don't know. I can't say what to do but all I would try is lightly roughing back with some wet and dry but this depends on the paint finish. No good making it worse I suppose. The best laquer I have found in a spraycan is Spraymax as its 2k in a can but its dangerous stuff so where a proper mask with filters. Once opened and mixed it will only last 24 hours. Done right, its hard and glossy very petrol resistant. Halfords stuff is only petrol resistant up to a point. I have seen it fail on a decent spray job and its not recommended on white paint as it turns it yellow.

Re: cbr400 rr

Posted: Tue Aug 12, 2014 7:53 pm
by thrushstar
cheers guys, might wait for the laquer to remove its self in about 10 years time. :peace: