Hi all,

Fitting my new rear braided brake hose was fine but when it came to routing through the securing clips on the chain guard it is to small to be able to effectively clamp.
What's the ideal way of securing it ? Just wondering what other people had done
Many thanks

Some kits come with rubber sleeves but you could make some from rubber or silicone pipe cut to size then just crimp the undertray and chainguard mounts over the sleeves sorted.

davethetrucker wrote:Some kits come with rubber sleeves but you could make some from rubber or silicone pipe cut to size then just crimp the undertray and chainguard mounts over the sleeves sorted.

Thank you , I was thinking along those lines but unsure how other folks had proceeded.
Cheers mate