Hi all,

Anyone grafted a tyga race MC28 tail section onto an NC30?

From photos, the frames, tank, and subframe mount points look similar.

Like getting this guy on:

http://tyga-performance.com/site/produc ... ts_id=1212

StrayAlien wrote:Hi all,

Anyone grafted a tyga race MC28 tail section onto an NC30?

From photos, the frames, tank, and subframe mount points look similar.

Like getting this guy on:

http://tyga-performance.com/site/produc ... ts_id=1212

There's one on eBay at the moment with this kit on and RVF forks. I'll try to add a link now pal. Fits ok but not the best look IMO

http://bit.ly/1cQSwE7

Thats not the same seat unit though

Drunkn Munky wrote:Thats not the same seat unit though

oh yeah :p my bad, does look similar though

Thanks, yes, looks similar, but not the tyga one.

The tyga MC28 race bodywork look great. I saw some fitted to a RGV framed / NS250 engined beast and it looked fantastic.

Many moons ago here I asked about the MC28 kit and one forum member had a MC28 front end on his (quite amazing) moto-gp replica. I am just looking to see if the tyga rear end fits.

im sure the mc28 seat will fit without too much effort,you would have to make a new subframe tho.

Wats the cans off?

Hi all,

to put this to bed, here is what tyga says:

"Sorry, the MC28 is very different to the NC30. Not only the subframe but the angles of the fuel tank etc. We’ve offered it up in the past and it wasn’t very promising."

fair enough.

I wouldnt settle for that for a answer....fibreglass is easy enough to alter,one of their 28 seats has removable sides were it meets the tank to make it easier.