Identifying a part?
Posted: Mon Nov 25, 2013 12:07 pm
Can anyone help me to identify this part that I uncovered amongst my vfr/rvf stuff lurking in my garage.
I have a sneaking suspicion that it may be an RS250 part but hopefully someone with a lot more knowledge on such things can shed some light on the subject.
The sizes are;
Overall length 207mm
Shaft diameter 17.63mm
Spline diameter 20mm
Thread length 23mm
Thread M18x1.5
The nut seems the same as the NC35 apart from no castellations for the retaining clip, but the collar has a taper where it would seat in the wheel recces. The vfr/rvf nut has a flat surface.
Thanks in advance for any help.






I have a sneaking suspicion that it may be an RS250 part but hopefully someone with a lot more knowledge on such things can shed some light on the subject.
The sizes are;
Overall length 207mm
Shaft diameter 17.63mm
Spline diameter 20mm
Thread length 23mm
Thread M18x1.5
The nut seems the same as the NC35 apart from no castellations for the retaining clip, but the collar has a taper where it would seat in the wheel recces. The vfr/rvf nut has a flat surface.
Thanks in advance for any help.





