hi all, i have buy FCR for FZR 400.
I have made ​​the project a line of carburetor for RVF 400.
I am looking for any information (blueprint, the brackets and linkages, drawings).

first questions spigot length (for installation in the engine nc 35)

I have a lot of photos detailing the linkages I can send you but diagrams/blueprints are non existant to my knowledge. Another problem you will have is geting the correct inlet rubbers as they kick off at an angle so the carbs fit offset in the frame.

Send me your email and I'll send the pics over, and if you manage to make a set of linkages I'll buy a set off you

I would also be interested in a set should you get them made

Is there any news/update on this?

Yakama wrote:I would also be interested in a set should you get them made

Me too!

How many kits of the linkages? I can ask for a group buy. I can copy the oem FCR 33mm linkages.
Boots you have to talk wit Mike Norman. He made a copy of my boots.
If it will help.

Michael

Some pics:













Michael

I would like a set of linkages if you get them made up. I have an FCR boot of Luke Millers that I was going to try and get copied. I will look into it further

I think we will need a min. of 5 sets.

Michael

Depending on costs I may take 2 sets. Can you get a quote for 5 sets then?