Page 1 of 1
Correct nc30 c spanner
Posted: Thu Oct 31, 2013 10:35 pm
by benny
Is this it? Was what I was recommended from here and was listed as nc30
Re: Correct nc30 c spanner
Posted: Thu Oct 31, 2013 11:11 pm
by Cammo
Looks like it to me.
It doubles as the shock preload adjusting tool (second tooth needed for this).
Edit: could be wrong about the preload adjustor, I think mines from a different model?
Re: Correct nc30 c spanner
Posted: Thu Oct 31, 2013 11:11 pm
by alexwitham
Mine does not look like that...
Re: Correct nc30 c spanner
Posted: Fri Nov 01, 2013 1:04 am
by hunter
That's not the original style,It was smaller than that.
Re: Correct nc30 c spanner
Posted: Fri Nov 01, 2013 2:23 pm
by Morespeedvicar
Big hammer and drift..........................
Re: Correct nc30 c spanner
Posted: Sat Nov 02, 2013 8:49 am
by JZH
The NC30/35,RC30/35 hub is a smaller diameter (105mm) than the RC45/46 (117mm), so each have specific Honda tools for adjustment. That said, you can probably get away with using a larger tool on a smaller hub (steady...)
Ciao,