Hi guys, So seen this advert for a nc30 on ebay. And asked the guy what seat unit is on the back. He said a honda rs 125 fairing. Do you think it would take alot of modification to get it fitted. I personally think it looks quite good even if the bike is not in the best condition

Here is the link

http://www.ebay.co.uk/itm/Honda-VFR-NC3 ... 4aca1b0903

And here is a pattern seat which i would use if it is not too much hassle.

http://www.ebay.co.uk/itm/HONDA-RS-125- ... 43b77c18ca

Cheers connor

Anything can be made to bolt on with enough work.

The bike on ebay has a custom subframe by the looks of it, you'd have to chop a lot off the standard one to fit the rs seat unit, then more work to get it to bolt up properly. It doesn't look like a standard battery tray would fit either.

Making a custom subframe from alloy box section would be the easiest way to get it to fit properly.

Cammo wrote:Anything can be made to bolt on with enough work.

The bike on ebay has a custom subframe by the looks of it, you'd have to chop a lot off the standard one to fit the rs seat unit, then more work to get it to bolt up properly. It doesn't look like a standard battery tray would fit either.

Making a custom subframe from alloy box section would be the easiest way to get it to fit properly.

Cool cheers for the info. Would one of rick olivers custom subframe work do you think?

No as thats to fit a standard seat unit, you need a subframe made to fit which unless you can weld isnt going to be cheap.

Drunkn Munky wrote:No as thats to fit a standard seat unit, you need a subframe made to fit which unless you can weld isnt going to be cheap.

Cool will look into it cheers. connor