I have heard that someone on here got the NC30 hub to fit into the NC24 swingarm, does anyone know what machining is involved to accomplish this and if sum of the components will need spaced out? Or is it possible to fit a VFR750F wheel on to the original hub, I know these have the same stud arrangement?

Hope someone can help

Thanks
Mark

Some info here viewtopic.php?f=22&t=29035

Ah that brings back memories I forgot who it was now

try searching.

take the lot to a machine shop and ask them?

I think the final result was to put the NC30 axle in the NC24 hub as is, just machine down the axle.

Thanks for the replies, think I have worked out what I need to do.