Decided to pull the plugs after a carb rebuild to check the colour only for the swine to snap off in the head! Decided the only course of action was to pull the head to prevent any shit dropping into the bores on removal and managed to get the remnants of the plug out without damaging the threads luckily! Now where is best to pick a gasket up from and are they the same as a gsxr or are they different?

What plugs are people using in these? I'm not so sure about putting NGK's back in after trying another and snapping that aswell with little to no force applied. Denso do an equivalent, any good or risk NGK again?

Look forward to the replies, I'm off to start de-coking the head!

Cheers, Lee.