Page 1 of 2
Cdi 12500rpm restriction Help
Posted: Thu Mar 14, 2013 3:37 pm
by Luke231
Hi I have an fzr 400 1wg 3en2 for trackday use still has a 12,500 rpm restriction and speedo been removed tried bdk engineering but they been a month doing my ecu don't think they know what there doing to be fair and bought one of them of eBay from china- shit rev counter doesn't work ideas?
Re: Cdi 12500rpm restriction Help
Posted: Thu Mar 14, 2013 4:29 pm
by willandrip
H Luke.
I noticed your original post on this in the General section.
Have you contemplated using the SP 2TK Tci,it was unrestricted hence needing no feedback from the speedometer but will allow over revving on a 1Wg engine by about 1.5k so care would be needed.
Problems may also arise if your exup valve is retained as the plug fitting is different for the servo.
I believe Boris has commented on this replacement in the past and may advise further.
viewtopic.php?f=35&t=28793
Two suitable units are currently available circa £40 on the usual auction site.
Re: Cdi 12500rpm restriction Help
Posted: Thu Mar 14, 2013 5:15 pm
by Luke231
Will keep an eye out for one :) stripped the ex up valve out so no probs there what sort of Rpm is max on the 1wg 13,500 14,000?
Re: Cdi 12500rpm restriction Help
Posted: Thu Mar 14, 2013 5:22 pm
by willandrip
1Wg=14000rpm
2TK=15500rpm (lightened valvetrain)
Re: Cdi 12500rpm restriction Help
Posted: Sun Mar 17, 2013 2:39 am
by Morespeedvicar
Hi, I've got a 2tk tci on me 3en1, i thought they all had them in a parts sharing stylee. The exup motors plugged in so i dunno how/if its been modded cos i thought it was all standard!
It says 2tk on the exhaust collector aswell!
Cheers
Ian
Re: Cdi 12500rpm restriction Help
Posted: Sun Mar 17, 2013 10:17 am
by willandrip
2TK
3EN1
3EN2
Notice the servo connection.

Re: Cdi 12500rpm restriction Help
Posted: Sun Mar 17, 2013 12:17 pm
by Evilchicken0
Ah well yes ... bit of history.
The Japanese didn't restrict bikes until 1988 so as the 2TK was built in 87 it has an unrestricted cdi
Re: Cdi 12500rpm restriction Help
Posted: Sun Mar 17, 2013 2:40 pm
by Kayla850
Evilchicken0 wrote:Ah well yes ... bit of history.
The Japanese didn't restrict bikes until 1988 so as the 2TK was built in 87 it has an unrestricted cdi
So would a 1986 Genesis CDI work on a 3EN2? I'm not bothered about the EXUP at all.
Re: Cdi 12500rpm restriction Help
Posted: Sun Mar 17, 2013 7:48 pm
by Evilchicken0
Don't know, I think the 2TK was more than just an exup. You'd have to look and see if the ignition curves are similar, then check if the wires go in or come out in the same place.
I'd alone use a M Max
Re: Cdi 12500rpm restriction Help
Posted: Sun Mar 17, 2013 8:01 pm
by Luke231
Gona buy a 2tk cdi see what happens put a bdk advance rotor on aswell so will be having a few hours on the dyno next month hopefully will report back