Page 1 of 1
Nc30 engine spacer size ?
Posted: Fri Mar 08, 2013 12:28 pm
by Dynamohum
Starting a build but have mislaid the bottom right spacer that goes between engine and frame on the long adjuster bolt 26 on the parts fiche which shows as 12mm which I take as m12 bolt size? I have one on other bikes but it's not practical to borrow remove , tried David silvers and lings but part nla
can anyone give me the dimensions of this part?
Re: Nc30 engine spacer size ?
Posted: Fri Mar 08, 2013 8:34 pm
by VFRkieran
Bugger if you had posted this just the other day id have measured it up for you, ive put the bloody engine back in the frame now
Re: Nc30 engine spacer size ?
Posted: Fri Mar 08, 2013 9:53 pm
by Dynamohum
Hunted high n low in garage must have rolled of when I stripped bike 5 months ago serves me right for being slow in rebuilding... Thanks anyway kieran .
Re: Nc30 engine spacer size ?
Posted: Sun Mar 10, 2013 11:09 am
by Dynamohum
Anyone
Re: Nc30 engine spacer size ?
Posted: Mon Mar 11, 2013 12:18 pm
by arsey30
Why not measure the width of the engine and the space between the frame and calculate the difference?
Re: Nc30 engine spacer size ?
Posted: Wed Mar 13, 2013 2:23 am
by Dynamohum
Looks like that's what I'm gonna have to do then I take it a m12 washer of the correct thickness is all that's required
