Page 1 of 1
Balancing carbs with a standard can then swapping for a race
Posted: Mon Mar 04, 2013 12:44 pm
by royster81
Tomorrow ill be balancing my carbs with gauges. But my neighbour is a paranoid schizophrenic and I don't want my bike idling in my driveway with a race can on incase it upsets him so I was going to swap it for a standard can to keep the noise down but will swapping cans back and forth have an effect on the carb balance ?
Re: Balancing carbs with a standard can then swapping for a
Posted: Mon Mar 04, 2013 12:59 pm
by CMSMJ1
Doubt it will make any difference at all matey
Re: Balancing carbs with a standard can then swapping for a
Posted: Mon Mar 04, 2013 1:02 pm
by The Novice
Doubt it, your balancing the pressure diff between each carb so realisticly that diff would be the same whatever end can was on I think.
Re: Balancing carbs with a standard can then swapping for a
Posted: Mon Mar 04, 2013 3:25 pm
by vfrman
No difference. You'll be ok.
Re: Balancing carbs with a standard can then swapping for a
Posted: Mon Mar 04, 2013 3:40 pm
by royster81
Cheers guys ill be getting started tomorrow but ill still fit the stock can.
Re: Balancing carbs with a standard can then swapping for a
Posted: Tue Mar 05, 2013 12:00 am
by Dynamohum
What is it with neighbours they get upset over a bike running but the sound of flymos and strimmers going at 100+decibels is the sound of summer lol..
Re: Balancing carbs with a standard can then swapping for a
Posted: Tue Mar 05, 2013 9:20 am
by royster81
I think it was all Gareth's fault.
Ill wait for him to come explain.
Re: Balancing carbs with a standard can then swapping for a
Posted: Tue Mar 05, 2013 3:11 pm
by Sam-NI
Maggot?
Re: Balancing carbs with a standard can then swapping for a
Posted: Tue Mar 05, 2013 6:50 pm
by royster81
No much worse.
Hit the limiter in my driveway between the two houses, not once but a handful of times.