Hi folks
Hope you're all having a merry crimbo.
I know this topic has prob been covered before but need wisdom.
tried to start project #2 today, been neglecting the NC's due to workload.
It ran ages ago but been standing since.
It had a service including new plugs at the time.
But now the bugger won't start. I checked plugs, all getting spark.
Took all 4 out, cleaned them & tried again with no luck.
Checked plugs again, rear 2 totally dry, front 2 wet & quite dark.
Battery was fully charged too

Any advice? Pull carbs off for a clean etc?
Thanks
Vic

Carb fettling time

new plugs time too...or bake them good and proper.

put the wet ones in the back as they might not get drowned so easy..

Thanks guys
Hoping to get more tinker time today so will see how things go.

Carbs seated properly Vic?

Not certain Chris, though pretty sure.
I'm starting again shortly, will check it out