Hi I was hoping you could just clarify a few things for me regarding the adjustable dogbone linkages you had fitted to one of your bikes, I think I've got the basic principles.

http://i124.photobucket.com/albums/p24/ ... inkage.jpg

Basically the rose joints do away with the necessity for bearings - is this correct?

presumably the best way of fabricating these "dogbones is to use a jig, something like these.

http://i124.photobucket.com/albums/p24/ ... 423754.jpg

http://i124.photobucket.com/albums/p24/ ... 423771.jpg

Thankyou for any advice in advance.

Riley wrote: Basically the rose joints do away with the necessity for bearings - is this correct?

Thankyou for any advice in advance.

It is correct. I use the oem linkages to set the new one.


Michael

Thankyou for that.