Hi there,

I have a cbr600 rear shock fitted and want to cure the large lean over angle when on the side stand.

I have thought about bolting a peice of rubber to the bottom of the existing stand but was wondering of another 'longer' stand would fit. I'm sure I rear once that a ZXR400 stand would fit and is longer than the NC29 one ??

cheers
Neil

or you can get a new dog bone fitted and not have to swap side stands.
cut side stand, add in a bit of rod, re-weld/paint. done

I'll have a look at the nc29 and nc30 stands I have at home this week.

Can't quite remember, but I think they might attach the same but are different lengths (not sure which way around!).