Can anyone tell me how much longer the NC29 side stand is compared to an NC35?

Thanks in advance and sorry if this has been asked before,

Jimmy

No one? Righteo then, I'm going ahead with a 1-off NC35 side stand made from 7075, +22 mm over standard length.

Will post pictures if it works out ...

I put an nc29 stand on my nc30 which fixed up the lean angle nicely (raised rear over standard).

I posted up the info here and if I recall it was only good for 30's, I think the 29 and 35 stands are a similar length.

In case it's useful, here a CBR900 92-99 stand that I used on my raised CB-1.

J.B. wrote:No one? Righteo then, I'm going ahead with a 1-off NC35 side stand made from 7075, +22 mm over standard length.

Will post pictures if it works out ...

Hi J.B.

How did you go with this?? Very curious as I'm in the same problem... very slanty RVF.

Ben.

Ben_OB1 wrote:

J.B. wrote:No one? Righteo then, I'm going ahead with a 1-off NC35 side stand made from 7075, +22 mm over standard length.

Will post pictures if it works out ...

Hi J.B.

How did you go with this?? Very curious as I'm in the same problem... very slanty RVF.

Ben.

Hey Ben,

I just picked it up last week but I have been seriously busy rebuilding my "new" RC31 so I haven't got around to fitting it yet. I'll post some pictures shortly. It LOOKS the business ... we'll see if it works or no ...

Jimmy

This turned out better than expected:

can anyone let me no if a35 and a 29 are longer than a 30 and will it bolt on raised rear to fix lean angle prob

john alex wrote:can anyone let me no if a35 and a 29 are longer than a 30 and will it bolt on raised rear to fix lean angle prob

I used a '29 sidestand on my nc30 to fix this problem, bolts straight on.

J.B. wrote:This turned out better than expected:

That looks really good. Did you make it yourself?