G'day,

Anybody ever have any issues fitting the Tyga triple clamp to their RVF?

It comes complete with new Honda ball type bearings and races however, it seems the stem runs out of thread before it nips up.

I also have new Honda nut and locknut.

I've pulled it all apart twice now and am a bit stumped, i'm no stranger to putting bikes together either so i feel a bit stupid?

Any ideas lads?

I have a nc30 with a Rick Oliver adaptor and had no issues fitting my tyga yokes.

The NC30 stem is shorter than the RVF's so is there a chance you have a 30 stem fitted?

That wouldn't surprise me Mr Frankenbike.

Drunkn Munky wrote:The NC30 stem is shorter than the RVF's so is there a chance you have a 30 stem fitted?

Tyga dont do a yoke set for nc35's as far as im aware.

marcus57 wrote:

Drunkn Munky wrote:The NC30 stem is shorter than the RVF's so is there a chance you have a 30 stem fitted?

Tyga dont do a yoke set for nc35's as far as im aware.

They have them listed on their site!

lukemillar wrote:

marcus57 wrote:

Drunkn Munky wrote:The NC30 stem is shorter than the RVF's so is there a chance you have a 30 stem fitted?

Tyga dont do a yoke set for nc35's as far as im aware.

They have them listed on their site!

Top yoke only

lukemillar wrote:http://tyga-performance.com/site/produc ... ts_id=1505

Id like to say im a prat and in my original post i ment to say nc30

All good lads, turns out the village idiot had the top bearing in upside down!!!