on doing my engine removal my carb rubbers came away with the carbs clips properly loose should i be worried about this or not

there was a positve clunk as they came off but i thought they were suppose to stay on the engine so are they worn

should of stuck to 2 strokes or singles nah

Did you loosen the upper or lower clamps or both before removing the carbs?

that may be the problem only one set of clamps carb side

should they be clamped to engine

i really have bought a pile of shite

yes there are clamps on both ends...
they should be done proper tight or it wont usually run right due to air leaks

otto wrote:i really have bought a pile of shite

lol! The good thing about hondas is that they usually go back together as well as they came apart.

Try a wanted ad in the classifieds for a set of lower carb clamps.