Hello,
Just changed the clutch on my NC30, now when i go to pull the clutch in there is pressure but it wont let me pull the lever back to the handle bar and also i cant see the clutch plates being pushed apart when operating the lever, any adivce would be helpful. Also when i wheel the bike round in neutral it makes a tinny clinking noise any ideas?

Streetfighterz1000 wrote:Hello,
Just changed the clutch on my NC30, now when i go to pull the clutch in there is pressure but it wont let me pull the lever back to the handle bar and also i cant see the clutch plates being pushed apart when operating the lever, any adivce would be helpful. Also when i wheel the bike round in neutral it makes a tinny clinking noise any ideas?

Something isn't right?

Strip it again. Theres a good video on here on how to replace NC30 clutch plates.. have a watch and then start again, rebuild clutch, cable and then adjust cable as necessary.

Probably something is not sitting right in the clutch

Sorted it now, turns out the spring holder wasnt engaged on the splines properly, all done now. Time to get her up and running!!!