hi there, my nc30 had a r1/r6 reg/rec put on but the original connector block was snipped off in favour of spade connectors. i am putting it back to standard after the electrical problems, but where do the wires go in respect to the underside of the standard reg/.rec ? ive got 3 yellow wires and i red and blue.
any help much appreciated.

Not sure if this helps, but this is the pin-out of the reg/rec on my 98 Fireblade... The third yellow wire goes in that smoldering hole in the upper right of the connector.

The red wire goes on the right pin the green on the left and the 3 yellow go on the bottom in any order it doesnt matter

rpg wrote:hi there, my nc30 had a r1/r6 reg/rec put on but the original connector block was snipped off in favour of spade connectors. i am putting it back to standard after the electrical problems, but where do the wires go in respect to the underside of the standard reg/.rec ? ive got 3 yellow wires and i red and blue.
any help much appreciated.

R1/R6 reg/rec is miles better than stock... really really worth keeping.