Hi guys,

Just wondering if there are any differences between the NC30 and NC35 standard carb needles? Need some standard ones in my NC30 and just want to check this out before I rip the ones out of my '35.

Cheers,

Ryan.

If somone can measure an NC35 needle, I'll measure an NC30 needle and see if there are any differences.

sounds great!

Im sure there was a chart someone did with measurements, rick o also did some, and some on akharas site (mike normans) i have measurements too but fuck knows where.

Rick

They're certain to be different, I'm not sure by how much though.

I can measure an nc35 needle after work tonight if it's any help.

Found what I was looking for on Akharas site. It is a gold mine of info!

The standard rvf needle (J8VA only) is approximately 39mm long, measured from under the under the head to the needle tip as per akhara's

Can get accurate measurements when I find my verniers...

Cheers for the advice guys. Ive got some standard needles now. their about 2 mm longer than my HRC ones!